Megger 1002-001 Insulation Tester Lead, For Use With BM100

Megger Insulation Tester Leads

The Megger insulation tester lead is a set of two leads used for BM100 insulation and continuity tester. This tester is used as a replacement or spare test lead set. These leads have 4mm connector and can be used with a range of multimeters, clamp meters, insulation testers, multifunction testers & continuity testers. For insertion into a difficult application, it has an extremely thin width, the length of the test leads is approximately 120cm, and that of the finger probes is 9cm.
Supplied with:
instructions, 2 wire test lead set with crocodile clips, 8 x AA alkaline batteries, neck strap & carry case.

Features and Benefits

Double insulated for additional protection
Red and Black Leads
4mm Right Angle Plugs on Instrument End
4mm Safety Probes and Croc Clips on Test End

Certifications

CAT III 1000 V