Fluke I1010 Multimeter Current Clamp Adapter, 1000A DC Max, AC/DC Adapter, 600A ac AC Max, Voltage Output - UKAS

Rugged current clamp adaptor suitable for use with multimeters to give non intrusive measurement of d.c. and a.c. current. Integral 1.2m 4mm shrouded plug lead.

Jaws accept conductor size of 1 x 30mm or 2 x 25mm dia.
d.c. current zero control for nulling out jaw/sensor offset
Superior noise immunity allows measurement in electrically noisy environments, such as adjustable speed drive line-side and load currents
Shielded, heat-resistant silicon rubber cable connects clamp to digital multimeter
Battery check mode
Compatible with meter input impedance ≥1MΩ
Conforms to IEC 1010-1 Cat III 600V

Supplied With: 9V PP3 alkaline battery and operators manual.

Use this current clamp from FLUKE when you need to measure flow without breaking a circuit. Wide jaws allow you to clamp the device over conductor diameters up to 30mm. Marks on each jaw arm help you reliably centre the conductor. A quick press of the lever opens and closes the jaws, so you can use the clamp one-handed for convenience. The 1.6m cable length means you'll have no problem reaching into awkward spaces.

• Hall-effect probe provides accurate readings from AC and DC circuits
• CAT III 600V safety category rating means it's safe to use on high-power busbars and distribution circuits
• Shrouded banana plugs protect you from shocks
• 60h battery life for dependability

• Automotive industry
• Medical equipment
• Telecommunications networks
• Consumer electronics
• Power distribution

This clamp measures DC currents between 1 and 1000A and AC currents between 1 and 600A, making it suitable for domestic and industrial circuits.

The product works with FLUKE multimeters, 120B series oscilloscopes and process meters. This includes the 125B scopemeter (919-5065), 789 series loop calibrator (449-4982) and 175 digital handheld multimeter (394-8826).